JTAG Interface Connectors
This page describes the JTAG interface connector pin-outs for the ARM and PowerPC processors used by DebugJet. These connectors can be used for debugging target systems as well as programming Flash or CPLD devices. It is recommended that the user implements the appropriate JTAG connector for the applicaple processor. Depending on the DebugJet configuration you order, you will get the appropriate connector for your target board.
Please contact EmuTec if a different processor is used and the user wishes to use DebugJet to perform JTAG test functions or to program onboard FLASH or CPLD devices.
Please use the pull-down menu below to choose a JTAG connector for your board.